Nissan Armada 2025-2026 Service and Repair Manual: Precautions for Removing Battery Terminal
NOTE:- NOTE:
- NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
BR08DE : 4 minutes R9N engine : 12 minutes BR10DE : 12 minutes V9X engine : 4 minutes D4D engine : 20 minutes YD25DDTi : 2 minutes HR09DET : 12 minutes YS23DDT : 4 minutes HR10DDT : 12 minutes YS23DDTT : 4 minutes HR10DET : 12 minutes ZD30DDTi : 60 seconds HR13DDT : 12 minutes ZD30DDTT : 60 seconds HRA2DDT : 12 minutes K9K engine : 4 minutes M9R engine : 4 minutes R9M engine : 4 minutes CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for Electronic Air Suspension System
WARNING:
CAUTION:
Never expand and contract the air spring of shock absorber.
Never expand and contract the air spring.
Never let foreign materials entered into parts.
Always check for the air leakage ...
Other materials:
Tools for Pulling
If it is impossible to gain access to the damaged area, dents can be pulled out and repaired.
METHODS
There are many techniques to repairing a dent, but there are basically two methods. Both methods can be used depending on the type of damage. Each method has its own advantages and disadvantages.
...
Exploded View
Without air suspension
Side step bracket Side step , , , , , : Indicates that the part is connected at points with same symbol in actual vehicle.
With air suspension
Side step bracket A Side step bracket C Side step Side step bracket B , , , , , : Indicates that the part is connected at poi ...
Inspection
INSPECTION AFTER REMOVAL
When turn the shaft in direction , check returning to direction by spring power.
CAUTION:
The maximum turning force shall be 5 N·m (0.51 kg-m, 44 in-lb).
When turn the shaft in direction , check locking the shaft. INSPECTION AFTER INSTALLATION
ADJUSTMENT AFTER INSTALLATIO ...
0.005