
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
Wiring DiagramSONAR SENSOR (FRONT) : Removal & Installation
WARNING:
REMOVAL
Center sensor
NOTE:
When removing the sensor holder, remove the front bumper. Refer to Removal and Installation.
Disconnect sonar sensor harness connector , follow the procedure below.Slide the lock of the connector toward the direction (1). Keep pushing (2) in the lock of connecto ...
Inspection of Welded Portions
Refer to the inspection method for spot welding. Refer to Inspection of Welded Portion.
Sample defects and welding conditions of MAG welding.
Defect Check points Remarks
Is correct wire selected?
Is gas sealed properly?
Is weld joint surface clean?
Is weld zone quickly cooled?
A hole is made w ...
Diagnostic Work Sheet
Description
In general, customers have their own criteria for a symptom. Therefore, it is important to understand the symptom and status well enough by interviewing the customer about the symptom carefully. To systemize all the information for the diagnosis, prepare the interview sheet referring to ...