
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
Wiring DiagramRemoval and Installation
CAUTION:
REMOVAL
Remove door mirror finisher. Refer to Disassembly and Assembly.
Remove side camera (if equipped). Refer to Removal and Installation.
Disconnect side turn signal lamp harness connector .
Remove side turn signal lamp fixing pawls , and then remove side turn signal lamp.
INSTALLATI ...
Removal and Installation
REMOVAL
Remove drain assembly. Refer to Removal and Installation.
Remove sunshade. Refer to Removal and Installation.
Remove side trim and glass lid guide from moonroof frame assembly.
Remove side trim from glass lid guide.
INSTALLATION
Note the following items, and then install in the reverse o ...
Removal and Installation
REMOVAL
WARNING:
CAUTION:
Never disassemble the front height sensor.
Start engine.
Turn OFF the electronic air suspension function. Refer to Operation.
Stop engine.
Lift up the vehicle.
Disconnect front height sensor harness connector.
Remove front height sensor.
INSTALLATION
Note the following, an ...