Nissan Armada 2025-2026 Service and Repair Manual: Precautions for Removing Battery Terminal
NOTE:- NOTE:
- NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
BR08DE : 4 minutes R9N engine : 12 minutes BR10DE : 12 minutes V9X engine : 4 minutes D4D engine : 20 minutes YD25DDTi : 2 minutes HR09DET : 12 minutes YS23DDT : 4 minutes HR10DDT : 12 minutes YS23DDTT : 4 minutes HR10DET : 12 minutes ZD30DDTi : 60 seconds HR13DDT : 12 minutes ZD30DDTT : 60 seconds HRA2DDT : 12 minutes K9K engine : 4 minutes M9R engine : 4 minutes R9M engine : 4 minutes CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
WARNING:
Always observe the following items for preventing accidental activation.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
Always observe the following items for preve ...
PRECAUTIONS FOR TROUBLE DIAGNOSIS : Precautions
AV COMMUNICATION SYSTEM
Do not apply voltage of 7.0 V or higher to the measurement terminals.
Use the tester with its open terminal voltage being 7.0 V or less.
Be sure to turn ignition/power switch O ...
Other materials:
Replacement
CAUTION:
HEADLAMP (Hi)
CAUTION:
Replacement of a single part is not possible due to the adoption of LED. For replacement, replace front combination lamp as a set. Refer to Removal and Installation.
HEADLAMP (Lo)
CAUTION:
PARKING LAMP
CAUTION:
DAYTIME RUNNING LIGHT
CAUTION:
FRONT TURN SIGNAL LAMP
CAU ...
Tracking Gauge and Steel Tape
Measure the distance between two points. Before using the tracking gauge, check the measuring points with the steel tape.
(1) TRACKING GAUGE
Fit the tracking gauge correctly to the measuring point.
The dimension is indicated between the hole center.
If measurement is unavailable, use the method sho ...
Work Flow
DETAILED FLOW
INTERVIEW FROM THE CUSTOMER
CAUTION:
>>
GO TO 2.
CHECK SYMPTOM
CAUTION:
>>
GO TO 3.
PERFORM SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis for “CHASSIS CONTROL”.
Is DTC detected?
YES>>
Record or print self-diagnosis results and freeze frame data (FFD). ...
0.0054