Nissan Armada 2025-2026 Service and Repair Manual: Precautions for Removing Battery Terminal

Nissan Armada 2025-2026 Service and Repair Manual / Driver Information & Multimedia / Recorder System — Precaution / Precautions / Precautions for Removing Battery Terminal

NOTE:
NOTE:
NOTE:

The removal of 12V battery may cause a DTC detection error.

HOW TO DISCONNECT 12V BATTERY TERMINAL

Disconnect 12V battery terminal according to instruction described below.

Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.

BR08DE	: 4 minutes	R9N engine	: 12 minutes
BR10DE	: 12 minutes	V9X engine	: 4 minutes
D4D engine	: 20 minutes	YD25DDTi	: 2 minutes
HR09DET	: 12 minutes	YS23DDT	: 4 minutes
HR10DDT	: 12 minutes	YS23DDTT	: 4 minutes
HR10DET	: 12 minutes	ZD30DDTi	: 60 seconds
HR13DDT	: 12 minutes	ZD30DDTT	: 60 seconds
HRA2DDT	: 12 minutes	K9K engine	: 4 minutes
M9R engine	: 4 minutes	R9M engine	: 4 minutes

CAUTION:

Remove 12V battery terminal.

CAUTION:

Precautions

...

Precautions for Driving Video Recorder System

Never disassemble the driving video recorder control module. The parts must not be reused if they are dropped. ...

Other materials:

Precautions for Removing Battery Terminal
NOTE: NOTE: NOTE: The removal of 12V battery may cause a DTC detection error. HOW TO DISCONNECT 12V BATTERY TERMINAL Disconnect 12V battery terminal according to instruction described below. Open the hood. Turn ignition switch to the ON position. Turn ignition switch to the OFF position with the d ...

EXHAUST SYSTEM : Removal & Installation
WARNING: REMOVAL Remove spare tire. Refer to Removal & Installation. Remove rear muffler with the following procedure: Loosen the mounting nut of the mounting bracket . CAUTION: Be careful not to hit the rear muffler with the tool. Remove mounting rubber 1 and rear muffler from the vehicle ...

Removal and Installation
WARNING: REMOVAL Remove valve timing control covers (bank 1 and bank 2). Refer to Removal & Installation. Remove electric intake valve timing control actuator (bank 1 and bank 2). Refer to Removal & Installation. Remove crankshaft pulley. Refer to Removal & Installation. Remove front cov ...

0.0063