
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
Precautions For Harness RepairAdjustment
WARNING:
Recommended fluid and fluid capacity : Refer to Fluids and Lubricants.
CAUTION:
Use only recommended A/T fluid. Never mix with other A/T fluid.
Always maintain the A/T fluid temperature within between 45°C (113°F) and 55°C (131°F) while checking with CONSULT when the A/T fluid level ...
Removal and Installation
REMOVAL
Fully open hood assembly.
Remove fixing clips .
Remove fixing clips .
Disengage front grille fixing clips to secure workspace, and then remove front grille upper .
: Clip
Disengage fixing clips and pawls, and then remove front grille.
: Clip : Pawl
Remove the following parts ...
Exploded View
Diagnosis sensor unit : Vehicle front : Always replace after every disassembly. : N·m (kg-m, in-lb) ...