
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
Work Procedure
REPLACE BCM
Replace BCM. Refer to Removal and Installation.
>>
GO TO 2.
WRITING Vehicle SPECIFICATION
Perform configuration (BCM). Refer to Description.
>>
GO TO 3.
PAIRING OF BCM AND INTELLIGENT KEY UNIT
CAUTION:
When before pairing of BCM and Intelligent Key unit, always writing ...
Hammering
Elongation of aluminum alloy during hammering will be greater than with steel plates. Therefore, a wooden or plastic hammer should be used with a softer blow to prevent stretching and work hardening of panels. Observe the following in case body filler is applied after hammering.
Apply wash primer a ...
Engine compartment
The engine compartment of the Nissan Armada houses the powerful VR35DDTT engine
and essential service components. Regular inspection of these elements helps maintain
optimal performance and long-term reliability.
Window washer fluid reservoir
Fuse/fusible link holder
Engine oil fille ...