CAUTION:
Follow the instructions listed below. Failure to do this may cause damage to parts:
Never apply 7.0 V or more to the measurement terminal.
Use a tester with open terminal voltage of 7.0 V or less.
Turn the ignition switch OFF and disconnect the battery cable from the negative terminal when checking the harness.
Precautions for Removing Battery Terminal
Precautions for Harness RepairDisassembly and Assembly
DISASSEMBLY
Remove door mirror assembly. Refer to Removal and Installation.
Remove door mirror cover. Refer to Removal and Installation.
Disconnect all terminals from harness connector .
NOTE:
Make a mark (short note, photo, etc.) of terminals layout, before disassembly.
Remove harness clip and v ...
Diagnosis Procedure
CHECK SEAT CONTROL UNIT POWER SUPPLY AND GROUND CIRCUIT
Check driver seat control unit power supply and ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHECK POWER SEAT SWITCH GROUND CIRCUIT
...
Exploded View
Rear door panel Inside seal Rear door sash inner cover Pull handle cap Inside handle cap Rear door finisher Pull handle bracket Grommet : Clip : Pawl : N·m (kg-m, in-lb) ...