Exploded View
 |
Circular clip |  |
Dust shield |  |
Housing |
 |
Snap ring |  |
Ball cage/steel ball/inner race assembly |  |
Stopper ring |
 |
Boot band |  |
Boot |  |
Shaft |
 |
Joint sub-assembly | ||||
| : Wheel side | |||||
 1: NISSAN genuine grease or an equivalent. |
|||||
| 2: Apply paste [service parts (440037S000)]. |
|||||
 : Always replace after every disassembly. |
|||||
Removal and Installation
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
NOTE:
Remove boot after drive shaft is removed from the vehicle.
-
Remove and install drive shaft. Refer to Removal and Installation.
-
Disassembly and assembly drive shaft. Refer to Disassembly and Assembly.
Other materials
Brake Pedal
Inspection and Adjustment
INSPECTIONBrake Pedal HeightCheck the height (H1) between the floor panel and the brake pedal upper surface. H1
: Refer to Brake Pedal.
CAUTION:
Remove the front floor carpet.Stop Lamp SwitchCheck the clearance (A) among the brake pedal lever and the stop lamp switch ...
High-Pressure Flexible Hose
Removal and Installation
REMOVALCAUTION:
Perform lubricant return operation before each refrigeration system disassembly. However, if a large amount of refrigerant or lubricant leak is detected, never perform lubricant return operation. Refer to Perform Lubricant Return Operation.
When disconnec ...
Normal Operating Condition
Description
SHIPPING MODE
Shipping mode inhibits battery power consumption during transportation or storage of the vehicle. Vehicle is set to shipping mode before being shipped from the factory.
When ignition switch is OFF, BCM operates shipping mode.
For shipping mode cancel operation, refer t ...