NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada owner manuals, service procedures, maintenance references, technical information and practical guides for different Armada generations.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Rear Wiper

Nissan Armada 2025-2026 Service and Repair Manual / Driver Controls / Wiper & Washer / Rear Wiper

Exploded View

Rear wiper motor Rear wiper blade Rear wiper arm
Pivot seal        
: N·m (kg-m, in-lb)

Rear Wiper Arm

Removal and Installation

CAUTION:

Clean back door window glass and rear wiper refill so that back door window glass may not be damaged by dust, etc.

REMOVAL

Operate rear wiper to the auto stop position. Refer to System Description.

Remove rear spoiler. Refer to Removal and Installation.

Remove rear wiper arm mounting nut.

Remove rear wiper arm.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:

  • Clean rear wiper arm installation location as shown in the figure, and then fully insert rear wiper arm to prevent nut from being loosened by shakiness.

  • Before installation, operate rear wiper to the auto stop position.

  • When installation, install so that it is within the specified position. And after installation, operate rear wiper, and then check that rear wiper blade stops at the specified position. Refer to Adjustment.

Adjustment

WIPER BLADE POSITION ADJUSTMENT

Set rear wiper blade as set position mark.

Rear wiper blade Back door window glass    
Set position mark        

Rear Wiper Blade

Removal and Installation

REMOVAL

Operate rear wiper to the service position. Refer to System Description.

Lift up rear wiper arm, and then lock back rear wiper arm.

Remove rear wiper blade from rear wiper arm while rotating rear wiper blade in the direction indicated by the arrows as shown in the figure.

CAUTION:

After rear wiper blade is removed, wrap rear wiper arm with a shop cloth and fold it down so that rear wiper arm does not fall against and damage back door window glass.

INSTALLATION

Install in the reverse order of removal.

Rear Wiper Motor

Removal and Installation

REMOVAL

Remove rear wiper arm. Refer to Removal and Installation.

Disconnect rear wiper motor harness connector and remove harness clip .

Remove rear wiper motor mounting bolts , and then remove rear wiper motor.

CAUTION:

Never drop rear wiper motor or cause it to come into contact with other parts.

Remove pivot seal from back door window glass.

INSTALLATION

Note the following item, and then install in the reverse order of removal.

CAUTION:

When rear wiper motor is replaced, before installing rear wiper arm, operate rear wiper to set rear wiper motor to the auto stop position, and then install rear wiper arm.

    Other materials

    Third Seat Belt Buckle
    Removal and Installation REMOVALSeat Belt Buckle LH and Connector BuckleRemove luggage floor board LH. Refer to Removal and Installation. Disconnect harness connector. Remove seat belt buckle LH and connector buckle mounting anchor bolt . Pull out seat belt buckle LH and connector buckle from thir ...

    Rear Seat Belt Warning (information Display) Does Not Operate
    Diagnosis Procedure CHECK DTC OF AIR BAG DIAGNOSIS SENSOR UNIT Check DTC in “Self Diagnosis Result” mode of “AIR BAG” using CONSULT. Is DTC detected? YES>> Perform trouble diagnosis related to the detected DTC. Refer to DTC Index. NO>> GO TO 2. CHECK COMBINATION METER Check com ...

    Configration (intelligent Key Unit)
    Description Vehicle specification needs to be written with CONSULT because it is not written after replacing the Intelligent Key unit.The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the vehic ...