Inspection
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
OIL LEAKAGE
Make sure that oil is not leaking from final drive assembly or around it.
OIL LEVEL
Check oil level from filler plug mounting hole as shown in the figure after removing filler plug
and gasket from final drive assembly.

CAUTION:
The ignition switch OFF while checking oil level.
-
Oil level should be level with bottom of filler plug hole. Add gear oil if necessary. Refer to Refilling.
Set a gasket on filler plug and install it on final drive assembly.
CAUTION:
Never reuse gasket.
Tighten filler plug to the specified torque. Refer to Exploded View.
Draining
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
The ignition switch OFF.
Remove drain plug
and gasket.

Drain gear oil.
Set a gasket on drain plug and install it to final drive assembly.
CAUTION:
Never reuse gasket.
Tighten drain plug to the specified torque. Refer to Exploded View.
Refilling
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
Remove filler plug
and gasket. Then fill with new gear oil until oil level reaches the specified level near filler plug mounting hole.

| Recommended oil and capacity | Refer to Fluids and Lubricants. |
Set a gasket on filler plug and install it on final drive assembly.
CAUTION:
Never reuse gasket.
Tighten filler plug to the specified torque. Refer to Exploded View.
Other materials
Parking Brake Control
Exploded View
Rear brake caliper assembly
Axle housing
Bracket
Parking brake actuator harness and rear wheel sensor
: vehicle front
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
Removal and Installation
WARNING:
Jacking up or lift up the vehicle ...
Third Seat Cushion
Disassembly and Assembly
DISASSEMBLYDisengage seat cushion trim fixing retainers .
Remove hinge cover (LH and RH).Remove fixing screw .
Disengage fixing pawl, and then remove hinge cover.
: Pawl
Remove seat cushion frame assembly mounting bolts .
Remove bushes from seat cushion frame ass ...
Moonroof Motor Assembly
Exploded View
Refer to Exploded View.
Removal and Installation
REMOVALCAUTION:
Before removing moonroof motor, check that glass lid is fully closed.
After removing moonroof motor, never attempt to rotate moonroof motor assembly as a single unit.
Remove headlining to make work space. Refer to Re ...