Inspection
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
OIL LEAKAGE
Make sure that oil is not leaking from final drive assembly or around it.
OIL LEVEL
Check oil level from filler plug mounting hole as shown in the figure after removing filler plug
and gasket from final drive assembly.

CAUTION:
The ignition switch OFF while checking oil level.
-
Oil level should be level with bottom of filler plug hole. Add gear oil if necessary. Refer to Refilling.
Set a gasket on filler plug and install it on final drive assembly.
CAUTION:
Never reuse gasket.
Tighten filler plug to the specified torque. Refer to Exploded View.
Draining
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
The ignition switch OFF.
Remove drain plug
and gasket.

Drain gear oil.
Set a gasket on drain plug and install it to final drive assembly.
CAUTION:
Never reuse gasket.
Tighten drain plug to the specified torque. Refer to Exploded View.
Refilling
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
Remove filler plug
and gasket. Then fill with new gear oil until oil level reaches the specified level near filler plug mounting hole.

| Recommended oil and capacity | Refer to Fluids and Lubricants. |
Set a gasket on filler plug and install it on final drive assembly.
CAUTION:
Never reuse gasket.
Tighten filler plug to the specified torque. Refer to Exploded View.
Other materials
Door Mirror Cover
Removal and Installation
REMOVALRemove glass mirror. Refer to Removal and Installation.
Apply protective tapes (A) on the part to protect it from damage.
Disengage door mirror cover fixing pawls from door mirror housing assembly .
: Pawl
Remove door mirror cover.INSTALLATIONNote the follow ...
Configuration (sonar Control Unit)
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the sonar control unit.The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the vehicle ...
Antenna Feeder
Feeder Layout
Vehicle Side
Without ProPILOT ASSIST 2.1
Antenna amp.
Window antenna (main)
Roof antenna (satellite)
Window antenna (sub)
Clip with connector (M324)
Clip with connector (M413)
Harness connector (M329)
Harness connector (M414)
H ...