Removal and Installation
CAUTION:
Never bend the fixing pawl of rear armrest.
REMOVAL
Remove rear door finisher. Refer to Removal and Installation.
Disconnect rear power window switch harness connector.
Remove rear armrest fixing screws 
, and then remove rear armrest 
from rear door finisher 
.
 |
: Pawl |
Remove rear power window switch from rear armrest .
|
: Pawl |
INSTALLATION
Install in the reverse order of removal.
Other materials
Input Oil Seal
Exploded View
Transfer assembly
Input oil seal
: vehicle front
: Always replace after every disassembly.
: Apply transfer fluid.
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and ...
Fuel Filler Lid Lock Assembly
Removal and Installation
REMOVAL Remove fuel filler base assembly. Refer to Removal and Installation.
Rotate and disengage fuel filler lid lock assembly fixing pawls according to the numerical order 1→2 indicated by arrows as shown in the figure, and then remove fuel filler lid lock assembly.
...
Vr35ddtt
Alternator
Engine
VR35DDTT
Type
A003TV8091
MITSUBISHI make
Nominal rating
(V - A)
14 - 230
Ground polarity
Negative
Minimum revolution under no-load
(When 13.5 V is applied)
(rpm)
Less than 1,500
Hot output current
(When 13.5 V is applied)
(A/rpm)
More t ...