Removal and Installation
REMOVAL
CAUTION:
When washer tube is disconnected/removed, washer fluid may come out so prepare a container to receive washer fluid and never allow washer fluid to be sprinkled.
Remove rear spoiler. Refer to Removal and Installation.
While pushing rear washer nozzle fixing pawl
, remove rear washer nozzle
with rear washer nozzle tube
in the direction of the arrow in the figure.

Remove rear washer nozzle tube from rear washer nozzle.
Remove connector from rear washer nozzle tube.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
Before installation, check rear washer nozzle (check valve). Refer to Inspection and Adjustment.
-
After installation, check rear washer nozzle spray position. Refer to Inspection and Adjustment.
Inspection and Adjustment
REAR WASHER NOZZLE (CHECK VALVE)
Inspection
Check that air can pass through by blowing forward direction (toward nozzle side), and check that air cannot pass through by sucking reverse direction (toward washer tank side).

REAR WASHER NOZZLE SPRAY POSITION
Inspection
NOTE:
Refer to the figure below for the rear washer nozzle spray position.

![]() |
Center | ![]() |
Edge of back door window glass | ||
![]() |
: Spray area |
Unit: mm (in)
![]() |
![]() |
![]() |
![]() |
|
|
X (from center) |
93.1 (3.67) |
64.2 (2.53) |
186.6 (7.35) |
158.4 (6.24) |
|
Y (from edge of back door window glass) |
37.7 (1.48) |
109.5 (4.31) |
134.6 (5.30) |
45.1 (1.78) |
Adjustment
Use washer nozzle adjuster (A) for rear washer nozzle
adjustment.

CAUTION:
Never use needle or small pin for adjustment.
Other materials
Rear Differential Gear Oil
Inspection
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
OIL LEAKAGEMake sure ...
Rear Wiper
Exploded View
Rear wiper motor
Rear wiper blade
Rear wiper arm
Pivot seal
: N·m (kg-m, in-lb)
...
Telematics Switch
Removal & Installation
REMOVALRemove the map lamp assembly. Refer to Removal and Installation.
Remove the microphone harness connector .
Use a suitable tool to release pawl and remove the switch finisher .
: Pawls
CAUTION:
Do not damage pawl.
Use a suitable tool to release pawls and rem ...





