WARNING:
The ignition switch OFF.

| Recommended fluid and capacity: | Refer to Fluids and Lubricants. |
CAUTION:
Carefully fill the fluid. (Fill up for approximately 3 minutes.)
Leave the vehicle for 3 minutes, and check the fluid level again.
Install filler plug on transfer and tighten to the specified torque.
CAUTION:
Never reuse filler plug.
| Specified torque | : 37.5 N·m (3.8 kg-m, 28 ft-lb) |
DrainingRemoval and Installation
CAUTION:
Never damage front door panel.
REMOVAL
CAUTION:
When removing, always use a remover tool that is made of plastic to prevent damage to the parts.
Fully open front door.
Remove pull handle cap.Apply protective tape (A) on front door finisher to protect it from damage.
Remove pull handle cap ...
Inspection
INSPECTION AFTER REMOVAL
Appearance
Check the following items, and replace the part if necessary.
Front lower link and bushing for deformation, cracks or damage.
Boot of ball joint for cracks or damage, and also for grease leakage.
Ball Joint Inspection
Manually move ball stud to confirm it moves s ...
General Specification
Applied model Axle 2WD Engine VR35DDTT Transmission A/T Rear final drive R240 without differential lock Propeller shaft model 3F C-C-C Number of joints 3 Joint type 1st joint Universal (Solid type) 2nd joint Universal (Solid Type) 3rd joint Universal (Solid Type) Coupling method ...