WARNING:
REMOVAL
The ignition switch OFF.
CAUTION:
Wait for 60 seconds after the ignition switch OFF.
Disconnect negative battery terminal. Refer to Removal and Installation.
Remove glove box cover. Refer to Removal and Installation.
Disconnect transfer control unit harness connector.
Remove transfer control unit bracket mounting nuts (
) and remove transfer control unit
with bracket.

INSTALLATION
Note the following, and install in the reverse order of removal.
When replacing transfer control unit, performe writing unit parameter and intial calibration. Refer to Description.
Exploded View
4wd Shift SwitchRepairable Frame Damages
In general, the following types and degrees of frame damages are considered repairable though the repairability may differ depending on the capacity of the frame straightening equipment in use.
(1) LONGITUDINAL DEFORMATION
Deformation located ahead of the lower link mount, the length of which is 100 ...
Exploded View
INSTRUMENT PANEL ASSEMBLY
Front speaker grille*1 Display unit cover Display unit Instrument panel assembly Instrument mask LH Instrument finisher A Display unit finisher LH Instrument pad A Steering column cover upper Steering column cover lower Instrument lower panel LH Glove box lid in ...
Basic information
WARNING
Never attempt to lift two wheels of the Nissan Armada off the ground
while the engine is running and shift the transmission into any drive or reverse
position. This improper procedure may cause severe drivetrain damage or unexpected
vehicle movement, potentially leading to serio ...