WARNING:
REMOVAL
Remove air breather hose A
from transfer assembly.

Remove clip A
.

Remove clip B
.

Remove A/T air breather hose. Refer to Removal and Installation.
Release clip C
and remove air breather hose assembly
from bracket.

Separate each component part.
INSTALLATION
Note the following, and install in the reverse order of removal.
For non-reusable parts, refer to Exploded View.

![]() | : Vehicle front |
Install air breather hose A with the paint mark
facing leftward.

![]() | : Vehicle front |

CAUTION:
Exploded ViewRemoval and Installation
WARNING:
REMOVAL
Ignition switch OFF.
CAUTION:
Wait for 60 seconds after the ignition switch OFF.
Disconnect negative battery terminal. Refer to Removal and Installation.
Disconnect the transfer range position sensor connector.
Remove the transfer range position sensor.
INSTALLATION
Note the follow ...
Commercial Service Tools
Tool name Description Drift
a: 61.0 mm (2.402 in) dia.
b: 56.3 mm (2.217 in) dia.
Installing front oil seal Drift
a: 66.3 mm (2.610 in) dia.
b: 61.9 mm (2.437 in) dia.
Installing rear oil seal Drift
a: 68.6 mm (2.701 in) dia.
b: 58.0 mm (2.283 in) dia.
Installing input oil seal Power tool
...
I-BSI driving situations
Indicator on
Indicator off
Indicator flashing
Illustration 1 - Approaching from behind
Another vehicle approaching from behind
Illustration 1: In the Nissan Armada, the side indicator light will illuminate
when a vehicle enters the detection zone from the rear in an adjacent lane, h ...