Nissan Armada 2025-2026 Service and Repair Manual: Removal and Installation
WARNING:
REMOVAL
Remove rear final drive assembly. Refer to Removal and Installation.
NOTE:
It is necessary to remove rear final drive assembly to remove/install the side oil seal.
Remove side oil seal, using side oil seal puller (A) [SST: KV10122000 (NI-53383)] and sliding hammer (B) (commercial service tool).
CAUTION:
Never damage gear carrier.
INSTALLATION
Note the following, and install in the reverse order of removal.
Install side oil seal until it becomes flush with the case end, using the side oil seal installer (A) [SST: KV10123000 (NI-53384)].
CAUTION:
Never reuse oil seal.
When installing, never incline oil seal.
Check that the oil seal lip is filled up with grease.
Perform inspection after installation. Refer to Inspection.
Exploded View
Rear final drive assembly Side oil seal : Vehicle front : Always replace after every disassembly. ...
Inspection
INSPECTION AFTER INSTALLATION ...
Other materials:
REAR VIEW CAMERA : Removal & Installation
REMOVAL
Remove back door finisher. Refer to Removal and Installation.
Remove the rear view camera mounting screws , then remove the rear view camera .
INSTALLATION
Install in the reverse order of removal.
NOTE:
Adjust the guide line position if the guide line position is shifted after installing t ...
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
Flat towing your vehicle
Flat towing
Flat towing—also referred to as dinghy towing or “4-down” towing—means towing
your Nissan Armada with all four wheels in contact with the ground.
This method is commonly used when a vehicle is towed behind a motorhome or recreational
vehicle. However, it is critical to unde ...
0.0051