Nissan Armada 2025-2026 Service and Repair Manual: Removal and Installation
WARNING:
REMOVAL
Remove tire. Refer to ROAD WHEEL TIRE : Removal & Installation.
When removing parking brake actuator harness and rear wheel sensor on the left side, remove the spare tire. Refer to Removal & Installation.
Disconnect parking brake actuator harness and rear wheel sensor harness connectors.
CAUTION:
Never twist and never pull rear wheel sensor harness, when removing.
Remove parking brake actuator harness and rear wheel sensor mounting bolts.
Remove parking brake actuator harness and rear wheel sensor.
CAUTION:
Never rotate or pull rear wheel sensor as much as possible, when pulling out.
INSTALLATION
Note the following, and install in the reverse order of removal.
Check that there is no foreign material like iron powder or damage on inner surface of rear wheel sensor mounting hole. Install after cleaning when there are foreign material like iron powder, or replace when there is a malfunction.
Never twist rear wheel sensor harness when installing rear wheel sensor. Check that grommet
is fully inserted to bracket 
. Check that rear wheel sensor harness is not twisted after installation.
Exploded View
Rear brake caliper Axle housing Bracket Parking brake actuator harness and rear wheel sensor : Vehicle front : N·m (kg-m, ft-lb) : N·m (kg-m, in-lb)
NOTE:
Rear RH wheel sensor is symmetric ...
Sensor Rotor
...
Other materials:
Tracking Gauge and Steel Tape
Measure the distance between two points. Before using the tracking gauge, check the measuring points with the steel tape.
(1) TRACKING GAUGE
Fit the tracking gauge correctly to the measuring point.
The dimension is indicated between the hole center.
If measurement is unavailable, use the method sho ...
Commercial Service Tools
Tool name Description Engine ear
Locates the noise Power tool
Loosening bolts, nuts, and screws Remover tool
Removes clips, pawls, and metal clips ...
Exploded View
Upper ball seat Steering knuckle Baffle Splash guard Wheel hub and bearing assembly Disc rotor Hub lock nut Hub bolt Cotter pin Lower ball seat : Comply with the installation procedure when tightening. Refer to Removal and Installation. : Vehicle front : N·m (kg-m, in-lb) : N·m (kg- ...
0.0052