Nissan Armada 2025-2026 Service and Repair Manual: Removal and Installation
REMOVAL
Remove spiral cable assembly. Refer to Removal and Installation.
Remove steering angle sensor from spiral cable.
INSTALLATION
Note the following, and install in the reverse order of removal.
When replacing the angle sensor
, if the lock pin 
is installed, remove the lock pin after installing the angle sensor to the spiral cable.
CAUTION:
Perform steering angle sensor neutral position adjustment when steering angle sensor is removed and installed, or replaced. Refer to Work Procedure.
Vdc Off Switch
...
Other materials:
Removal and Installation
CAUTION:
Never damage the back door panel.
REMOVAL
CAUTION:
Fully open back door.
Apply protective tape (A) on back door lower finisher to protect it from damage.
Disengage back door finisher cap fixing pawls using a remover tool (A), and then remove back door finisher cap.
: Pawl
INSTALLATIO ...
Inspection
WARNING:
DESCRIPTION
Measure wheel alignment under unladen conditions.
NOTE:
“Unladen conditions” means that fuel, engine coolant, and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions.
PRELIMINARY CHECK
Check the following:
Tires for improper air pressure an ...
Hill descent control system
Basic information
WARNING
Do not rely solely on the Hill Descent Control system in the Nissan Armada
to regulate speed on steep downhill slopes. Always maintain full control of
the vehicle and use the brake pedal when necessary. Extra caution is required
on slippery, muddy, icy, or ext ...
0.0051