Nissan Armada 2025-2026 Service and Repair Manual: Removal and Installation
WARNING:
Always observe the following items for preventing accidental activation.
Never use air tools or electric tools for servicing.
REMOVAL
Remove engine under cover front. Refer to Removal and Installation.
Disconnect crash zone sensor harness connector.
Remove crash zone sensor mounting nut, and then remove crash zone sensor.
CAUTION:
To prevent damage to the parts, never impact the crash zone sensor.
Replace crash zone sensor if it is dropped or sustains an impact.
Replace crash zone sensor of deployed driver air bag module, deployed passenger air bag module, deployed driver knee air bag module, deployed passenger knee air bag module, seat belt pre-tensioner and deployed lap pre-tensioner.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
Never reuse mounting nut after removal, replace with new one.
Always install normally aligning to the cutout hole, because performance of the crash zone sensor excessively fluctuates according to the installation position.
Exploded View
Crash zone sensor Radiator core support lower : Vehicle front : Always replace after every disassembly. : N·m (kg-m, ft-lb) ...
Satellite Sensor
...
Other materials:
Removal and Installation
CAUTION:
REMOVAL
Remove side turn signal lamp. Refer to Removal and Installation.
Remove puddle lamp harness connector from door mirror housing assembly .
: Vehicle front
Disconnect puddle lamp harness connector.
Remove puddle lamp fixing screw, and then remove puddle lamp assembly.
Disengage ...
Diagnosis Procedure
CHECK TELEMATICS SYSTEM SYMPTOM TABLE
Check telematics system symptom table. Refer to Symptom Table.
>>
GO TO 2.
CHECK INTELLIGENT KEY SYSTEM (REMOTE KEYLESS ENTRY FUNCTION)
Lock/unlock door with Intelligent Key. Refer to System Description.
Is the inspection result normal?
YES>>
GO T ...
Inspection
WARNING:
OIL LEAKAGE
Make sure that oil is not leaking from final drive assembly or around it.
OIL LEVEL
CAUTION:
The ignition switch OFF while checking oil level.
Oil level should be level with bottom of filler plug hole. Add gear oil if necessary. Refer to Refilling.
Set a gasket on filler plug ...
0.0071