REMOVAL
Remove rear ventilator duct 1. Refer to Removal and Installation.
Remove mounting bolt
, and then remove rear ventilator connecting duct.

INSTALLATION
Install in the reverse order of removal.
Blower UnitWork Procedure
When driver monitor camera control unit is replaced, be sure to perform the specified incidental work in order to operate system normally.
DRIVER MONOTOR CAMERA CONTROL UNIT CONFIGURATION
>>
GO TO 2.
CHECK DATA MONITOR
Check that "Face" is "within range" in "Data monitor" of "Driver Monitor ...
Exploded View
Headlining assembly Personal lamp Personal lamp bracket : Pawl : Vehicle front ...
Removal and Installation
REMOVAL
Remove spiral cable assembly. Refer to Removal and Installation.
Remove steering angle sensor from spiral cable.
INSTALLATION
Note the following, and install in the reverse order of removal.
When replacing the angle sensor , if the lock pin is installed, remove the lock pin after installing ...