Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure
When driver monitor camera control unit is replaced, be sure to perform the specified incidental work in order to operate system normally.
DRIVER MONOTOR CAMERA CONTROL UNIT CONFIGURATION
>>GO TO 2.
CHECK DATA MONITOR
Check that "Face" is "within range" in "Data monitor" of "Driver Monitor Camera".
Is the inspection result normal?
YES>>GO TO 3.
NO>>Check installation status of the driver monitor camera control unit (installation position, specified tightening torque, bending of bracket, etc.).
PERFORM SELF-DIAGNOSIS
Check that DTC is detected in self-diagnosis result of "Driver Monitor Camera".
Is DTC detected?
YES>>Perform a diagnosis of detected DTC and repair or replace the malfunction parts. Refer to DTC Index.
NO>>WORK END
Other materials:
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table.
Refer to Diagnosis Procedure.
>>
GO TO 2.
CHECK INTELLIGENT KEY BATTERY
Check the Intelligent Key battery.
Refer to Component Inspection.
Is the inspection result normal?
YES>>
GO TO 3.
NO>>
...
Removal and Installation
CAUTION:
Never damage the back door panel.
REMOVAL
CAUTION:
Fully open back door.
Apply protective tape (A) on back door lower finisher to protect it from damage.
Disengage automatic back door switch finisher fixing pawls using a remover tool (A).
: Pawl
Disconnect harness connectors, and the ...
Disposal
Fix the electrical brake control unit to a vise.
CAUTION:
Always set copper plates or cloth between vise grips when fixing the electrical brake control unit to a vise.
Never overtighten the vise.
Make a slit in the area (A) with a saw to release filler gas.
A : 50 mm (1.97 in)
CAUTION:
Wear ...
0.0099