CAUTION:
Perform work with 2 workers, because it is heavy weight.
Support door with a proper material and use protective tape or shop cloth to protect door and body from falling and damage when removing and installing door assembly.
REMOVAL
Remove rear door harness grommet from vehicle body, and then pull out rear door harness and disconnect rear door harness connector.
Remove rear door check link mounting bolt of vehicle body side.
Support rear door assembly with a proper material to prevent it from falling.
WARNING:
Injury may occur if door assembly is not supported with a proper material when removing rear door assembly.
Remove rear door hinge mounting nuts, and then remove rear door assembly.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
Before installation, apply anticorrosive agent onto the mounting surface.
When installation, perform the fitting adjustment. Refer to Adjustment.
After installation, apply touch-up paint (the body color) onto the head of rear door hinge mounting nuts.
After installation, check the open/close operation. Refer to Inspection.
After installation, apply anticorrosive around the nuts to prevent rust.
InspectionInspection and Repair
INSPECTION
When measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger.
Attach probe circuit tester (in Volt range) to middle portion of each filament.
If a filament is burned out, circuit tester registers 0 or battery voltage ...
Engine Does Not Start When Intelligent Key Is Inside of Vehicle (one Key)
Engine does not start when push-button ignition switch is pressed. (One Intelligent Key has the symptom, other keys operate normally.)
Door lock operation (remote keyless entry) Door lock operation (request switch of front/rear door) or trunk/back door open operation (opener switch of trunk/back d ...
Exploded View
CAUTION:
Never remove or disassemble parts unless instructed as shown in the figure.
High pressure fuel pump insulator High pressure fuel pump O-ring High pressure fuel pump lifter Bracket Holder Fuel feed hose To fuel rail (bank 1). Refer to Exploded View. To centralized under-floor piping. ...