Nissan Armada 2025-2026 Service and Repair Manual: Removal and Installation
REMOVAL
Fully open hood assembly.
Remove front wiper arm (LH and RH). Refer to Removal and Installation.
Remove cowl top side seal.
Disconnect front washer tube connector.
CAUTION:
When washer tube is disconnected, washer fluid may come out so prepare a container to receive washer fluid and never allow washer fluid to be sprinkled.
Remove cowl top cover fixing clips and cowl top clips.
Pull forward to release cowl top cover from windshield glass, and then remove cowl top cover.
CAUTION:
When performing the procedure after removing cowl top cover, cover the lower end of windshield glass with urethane etc.
Remove the following parts after removing cowl top cover.
Cowl top seal
Washer nozzle. Refer to Removal and Installation.
Washer tube. Refer to Removal and Installation.
EPT seal
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
Always replace cowl top side seal and cowl top cover EPT seal with a new one when installing old cowl top cover.
After installing, perform adjustment of wiper arms. Refer to Adjustment.
Exploded View
Cowl top seal Cowl top side seal EPT seal [t: 15.0 mm (0.591 in)] Cowl top cover Cowl top clip EPT seal [t: 3.0 mm (0.118 in)] EPT seal [t: 10.0 mm (0.394 in)] EPT seal [t: 10.0 mm (0.394 in) ...
Front Spoiler
...
Other materials:
Inspection
LEVEL
Check if the reservoir tank engine coolant level is within the “MIN” to “MAX” when the engine is cool.
: MAX : MIN
Adjust the engine coolant level if necessary.
WARNING:
Never remove reservoir tank cap when engine is hot.
CAUTION:
Refill Genuine NISSAN Long Life Antifreeze/Coolant ...
ELECTRIC INTAKE VALVE TIMING CONTROL MODULE : Exploded View
Bracket Electric intake valve timing control module : Vehicle front : N·m (kg-m, in-lb) ...
Garage mode system
The Nissan Armada liftgate height can be customized to suit specific environments,
such as garages with limited clearance.
1. Open the Nissan Armada liftgate fully.
2. Manually adjust the liftgate to the desired height and hold it in position.
3. Press and hold the liftgate close and lock switc ...
0.0076