Nissan Armada 2025-2026 Service and Repair Manual: Removal and Installation
REMOVAL
Remove front center console rear finisher assembly. Refer to Removal and Installation.
Press the USB power socket fixing pawl from the back of the front center console rear finisher assembly to remove the USB power socket.
 | : Pawl |
INSTALLATION
Note the following, and install in the reverse order of removal.
Align the cut outs of USB power socket and front center console rear finisher assembly.
 | : Cut out |
Other materials:
Inspection and Adjustment
SYSTEM INITIALIZATION
Perform additional service for operating the power window control system normally after installing front door glass. Refer to Work Procedure.
FITTING INSPECTION
Check that glass is fitted securely into the sash groove.
Lower glass slightly [approximately 10 to 20 mm (0.39 to 0. ...
Exploded View
REMOVAL
Propeller shaft assembly
: Vehicle front : N·m (kg-m, ft-lb) : Always replace after every disassembly.
DISASSEMBLY
Snap ring Journal bearing Journal Flange yoke Propeller shaft (1st shaft) Propeller shaft (2nd shaft)
: Vehicle front : Always replace after every disassembly. : Ap ...
Basic information
The Idling Stop System in the Nissan Armada is designed to enhance fuel efficiency,
reduce exhaust emissions, and minimize unnecessary engine noise during short stops
such as traffic lights or congestion.
When the Nissan Armada comes to a complete stop, the system automatically
shuts off ...
0.0049