Nissan Armada 2025-2026 Service and Repair Manual: Removal and Installation
CAUTION:
When replacing the combination meter, always replace it with a new one. The functions controlled by the combination meter does not operate properly in case of reuse of the combination meter from another vehicle.
Be sure to perform the configuration when replacing combination meter. Refer to Work Procedure.
REMOVAL
Disconnect the battery cable from the negative terminal.
Remove display unit. Refer to Removal and Installation.
Remove the mounting screws 
of the combination meter 
.
Pull the combination meter outward, then disconnect harness connectors and remove.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
When replacing the combination meter, always replace it with a new one. The functions controlled by the combination meter does not operate properly in case of reuse of the combination meter from another vehicle.
Be sure to perform the configuration when replacing combination meter. Refer to Work Procedure.
Display Unit
...
Other materials:
Inspection
NOTE:
If the hood lock control cable assembly is bent or deformed, replace it.
Check that secondary latch is securely engaged with bracket from dead load of hood assembly.
Check that primary latch is securely engaged with hood striker when hood assembly is closed [freefall from approximately 200 m ...
Disassembly and Assembly
DISASSEMBLY
Remove side shaft assembly. Refer to Disassembly and Assembly.
Remove differential assembly. Refer to Disassembly and Assembly.
While holding companion flange with the flange wrench (A) (commercial service tool), remove drive pinion lock nut.
Put matching mark on the end of drive pini ...
Removal and Installation
WARNING:
REMOVAL
The ignition switch OFF.
CAUTION:
Wait for 60 seconds after the ignition switch OFF.
Disconnect negative battery terminal. Refer to Removal and Installation
Disconnect the transfer control actuator connector .
Remove harness clip .
Remove transfer control actuator mounting bolt ...
0.0074