Nissan Armada 2025-2026 Service and Repair Manual: Removal and Installation
WARNING:
REMOVAL
The ignition switch OFF.
CAUTION:
Wait for 60 seconds after the ignition switch OFF.
Disconnect negative battery terminal. Refer to Removal and Installation
Disconnect the transfer control actuator connector 
.
Remove harness clip .
Remove transfer control actuator mounting bolt (
) and remove bracket .
Remove transfer control actuator .
INSTALLATION
Note the following, and install in the reverse order of removal.
Never damage oil seal of transfer control actuator.
Never contaminate or damage the oil seal mounting surface.
Perform inspection after installation. Refer to Inspection.
Exploded View
Transfer assembly Transfer control actuator bracket : N·m (kg-m, in-lb) ...
Inspection
INSPECTION AFTER REMOVAL
Check the oil seal assembled transfer control actuator for wear, crack and damage. Replace if there is malfunction.
Check the transfer assembly as follows.Install the suitable ...
Other materials:
Light Stand
Over the years the light system has evolved from a single neon to multi lines and then to the reflector type light.
Small Light (1)Large Light (2) Advantage Disadvantage Advantage Disadvantage Lower price
Easy to apply
Lower light quality
Longer learning time
Difficult to achieve high quality
...
Removal and Installation
WARNING:
REMOVAL
Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.
Remove stabilizer connecting rod mounting nuts.
Remove mounting bolts, and remove stabilizer bar assembly from vehicle.
Remove stabilizer connecting rods, stabilizer clamps, and stabilizer bushings from stabilizer ...
DEFINITIONS OF BANK NAMES
In this manual, each bank name is defined as follows:
: Bank 1 (The conventional right bank) : Bank 2 (The conventional left bank) : Engine front
For cylinder numbers and bank layout, refer to the illustration.
Bank 1 : The bank side including cylinder No. 1
(odd-numbered cylinder side) Bank ...
0.0071