NOTE:
If the hood lock control cable assembly is bent or deformed, replace it.
Check that secondary latch is securely engaged with bracket from dead load of hood assembly.
Check that primary latch
is securely engaged with hood striker
when hood assembly is closed [freefall from approximately 200 mm (7.87 in) height].

CAUTION:
Never free-fall hood assembly from a height of 300 mm (11.81 in) or more.
While operating the hood lock control handle carefully, check that the front end of the hood is lifted by approximately 20 mm (0.79 in) (C). Also, check that the hood lock control handle returns to the original position.

![]() | Hood striker | ![]() | Primary latch |
Check that operating force of hood lock control handle shall be less than 49 N (5.0 kg, 11.0 lb).
Check pitch that secondary latch
is properly engaged with hood striker
[8.1 mm (0.319 in) MIN] (D).

Install so that static closing force of hood is 490 N (50.0 kg, 110.0 lb) or Less.
Check the hood lock assembly lubrication condition. If necessary, apply body grease to hood lock assembly.

![]() | : Body grease |
Removal and InstallationRemoval and Installation
CAUTION:
Never damage the body panel.
REMOVAL
Remove front kicking plate. Refer to Removal and Installation.
Remove hood lock control handle (driver side). Refer to Removal and Installation.
Disengage dash trim clip from dash side finisher.
Disengage dash side finisher fixing clips, and then remo ...
Exploded View
O-ring Rear companion flange Rear oil seal Transfer assembly : N·m (kg-m, ft-lb) : Always replace after every disassembly. : Apply transfer fluid. ...
How to use remote keyless entry function
WARNING
In the Nissan Armada, radio frequency signals generated by the Intelligent
Key may interfere with certain medical devices.
Individuals using pacemakers or other electronic medical equipment should
consult the device manufacturer before using the Nissan Armada Intelligent Key.
...