Inspection
-
Check valve seat
of reservoir tank cap.
: Metal plunger -
Check if valve seat is swollen to the extent that the edge of the metal plunger cannot be seen when watching it vertically from the top.
-
Check if valve seat has no soil and damage.
-
-
Pull negative-pressure valve to open it, and check that it close completely when released.
-
Check that there is no dirt or damage on the valve seat of reservoir tank cap negative-pressure valve.
-
Check that there are no unusualness in the opening and closing conditions of negative-pressure valve.
-
-
Check reservoir tank cap relief pressure.
Standard and limit : Refer to RADIATOR : Service Data. -
When connecting reservoir tank cap to the radiator cap tester (commercial service tool) and the radiator cap tester adapter (commercial service tool) (A), apply engine coolant to the cap seal surface.
-
-
Replace reservoir tank cap if there is an unusualness related to the above three.
CAUTION:
When installing reservoir tank cap, thoroughly wipe out the reservoir tank to remove any waxy residue or foreign material.
Other materials
Service Information for Electrical Incident
Work Flow
WORK FLOW STEP DESCRIPTION
STEP 1
Get detailed information about the conditions and the environment when the incident occurred.
The following are key pieces of information required to make a good analysis:
WHAT
vehicle Model, Engine, Transmission/Transaxle and the System (i.e. Ra ...
Second Seat Belt Retractor
Removal and Installation
WARNING:
Before servicing, disconnect ground line of battery. Refer to Precautions for Removing Battery Terminal.
Prevent accidental activation. Refer to Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER".
REMOVALSeat Belt Pre-ten ...
Around View Monitor Tools and Preparation
Preparation
Commercial Service Tools
Tool Description
Power tool
Loosening screws
Special Service Tools
Tool number
(TechMate No.)
Tool name Description
KV9912-0000
(—)
Laser marker
Use for calibration
...