Inspection
Check radiator for mud or clogging. If necessary, clean radiator as per the following:
-
Be careful not to bend or damage radiator fins.
-
When radiator is cleaned without removal, remove all surrounding parts such as radiator cooling fan assembly and horns. Then tape harness and connectors to prevent water from entering.
Apply water by hose to the back side of the radiator core vertically downward.
Apply water again to all radiator core surfaces once per minute.
Stop washing if any stains no longer flow out from radiator.
Blow air into the back side of radiator core vertically downward.
-
Use compressed air lower than 490 kPa (5 kg/cm2, 71 psi) and keep distance more than 30 cm (11.8 in).
Blow air again into all the radiator core surfaces once per minute until no water sprays out.
Other materials
Differential Lock Control Unit
Exploded View
Differential lock control unit
: vehicle front
: N·m (kg-m, in-lb)
Removal and Installation
REMOVALThe ignition switch OFF.
CAUTION:
Wait for 60 seconds after the ignition switch OFF.
Disconnect negative battery terminal. Refer to Removal and Insta ...
Rear A/c Control
Exploded View
Refer to Exploded View.
Removal and Installation
REMOVALRemove front center console rear finisher assembly. Refer to Removal and Installation.
Remove fixing screws , and then remove rear A/C control assembly.
Remove fixing screws , and then remove rear A/C control from rear A/C contr ...
Glove Box Lid Lock Cylinder
Exploded View
Glove box assembly
Sleeve
Glove box lid lock cylinder
Removal and Installation
REMOVAL NOTE:
Glove box lid lock key cylinder is integrated with glove box assembly. So, glove box lid lock key cylinder cannot be removed from glove box assembly and it cannot be replaced without ...