Check valve seat
of reservoir tank cap.

![]() | : Metal plunger |
Check if valve seat is swollen to the extent that the edge of the metal plunger cannot be seen when watching it vertically from the top.
Check if valve seat has no soil and damage.
Pull negative-pressure valve to open it, and check that it close completely when released.

Check that there is no dirt or damage on the valve seat of reservoir tank cap negative-pressure valve.
Check that there are no unusualness in the opening and closing conditions of negative-pressure valve.
Check reservoir tank cap relief pressure.
| Standard and limit | : Refer to RADIATOR : Service Data. |
When connecting reservoir tank cap to the radiator cap tester (commercial service tool) and the radiator cap tester adapter (commercial service tool) (A), apply engine coolant to the cap seal surface.

Replace reservoir tank cap if there is an unusualness related to the above three.
CAUTION:
When installing reservoir tank cap, thoroughly wipe out the reservoir tank to remove any waxy residue or foreign material.
Removal and Installation
REMOVAL
Rear Door Parting Seal Front
Fully open rear door.
Remove rear door parting seal front clip.Apply protective tape (A) to rear door panel around rear door parting seal front clip for preventing damage.
Disengage fixing pawls using a remover tool (A), and then remove rear door parting seal f ...
PRECAUTIONS FOR REMOVING BATTERY TERMINAL : Precautions
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
Commercial Service Tools or/and Repair Part
Tool name Description Tube presser
Pressing the tube of liquid gasket Power tool
Loosening nuts and bolts TORX socket
Removing and installing drive plate Mobile floor crane
Removing and installing engine Belt slinger
Removing and installing engine 1.Compression gauge
2.Adapter
Che ...