Nissan Armada 2025-2026 Service and Repair Manual: Commercial Service Tools or/and Repair Part
| Tool name | Description | |
|---|---|---|
| Tube presser |
| Pressing the tube of liquid gasket |
| Power tool |
| Loosening nuts and bolts |
| TORX socket |
| Removing and installing drive plate |
| Mobile floor crane |
| Removing and installing engine |
| Belt slinger |
| Removing and installing engine |
1.Compression gauge 2.Adapter |
| Checking compression pressure |
| Spark plug wrench |
| Removing and installing spark plug  : 14 mm (0.55 in) |
| Valve seat cutter set |
| Finishing valve seat (EXH) dimensions |
| Piston ring expander |
| Removing and installing piston ring |
| Valve guide drift |
| Removing and installing valve guide (EXH) Exhaust:
 : 5.5 mm (0.217 in) dia. |
| Valve guide reamer |
|
Exhaust:
 : 10.2 mm (0.402 in) dia. |
| Anti-seize lubricant (Permatex 133AR or equivalent meeting MIL specification MIL-A-907) |
| Lubricating oxygen sensor thread cleaning tool when reconditioning exhaust system threads |
| Feeler gauge |
| Inspection valve clearance (Use a curved-tip gauge) |
: Reaming valve guide (EXH) inner hole
: Reaming hole for oversize valve guide (EXH)
: 6.0 mm (0.236 in) dia.
Special Service Tool
The actual shapes of TechMate tools may differ from those of special service tools illustrated here.
Tool number
(TechMate No.)
Tool name Description KV10116200
(NI-26336-A)
Valve spring compressor
1 ...
Lubricant or/and Sealant
Name Description Note Three bond 1215 Cylinder block Water drain plug Three bond 1217H Rocker cover
Valve timing control cover
Front cover
Oil pan (upper)
Camshaft
Cylinder block
— Three b ...
Other materials:
Removal and Installation
WARNING:
REMOVAL
CAUTION:
When washer level switch is removed, washer fluid may come out so prepare a container to receive washer fluid and never allow washer fluid to be sprinkled.
Remove fender protector RH. Refer to Removal and Installation.
Disconnect washer level switch harness connector .
Re ...
Welding of Ultra High Strength Steel
SPOT WELDING
Spot welding is limited to ultra high strength steel (tensile strength: 980 MPa) according to the welding conditions listed below.
CAUTION:
If the below welding conditions cannot be met, then perform plug welding.
Never spot weld ultra high strength steel of tensile strength more than 9 ...
Disassembly and Assembly
CAUTION:
DISASSEMBLY
Remove armrest (LH seat).Disengage fixing pawls using a remover tool (A), and then remove armrest hinge cover RH.
: Pawl
Remove armrest mounting bolt and armrest hinge mounting nuts .
Remove armrest hinge and armrest hinge bracket RH as a set from center seatback frame. ...
0.0116