Exploded View
 |
Roof antenna | ||||
 |
: N·m (kg-m, in-lb) | ||||
Removal and Installation
REMOVAL
Remove the headlining assembly. Refer to Removal and Installation.
Disconnect the antenna feeder connector.
Remove the mounting nut
.
Remove the roof antenna from the vehicle.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
Be careful about tightening torque. Antenna sensitivity becomes poor, and when it is excessive, roof panel may be deformed, when roof antenna mounting bolt tightening torque is loose.
Other materials
Second Seat Belt Buckle
Removal and Installation
REMOVALCaptain SeatRemove inside seat cushion finisher outer. Refer to Disassembly and Assembly.
Disconnect seat belt buckle harness connector and disengage harness clips.
Remove seat belt buckle mounting anchor bolt, and then remove seat belt buckle.Bench SeatRemove the fol ...
Front Door Parting Seal
Removal and Installation
REMOVALFront Door Parting Seal FrontFully open front door.
Apply protective tape (A) to front door panel around front door parting seal front for preventing damage.
Disengage fixing clips on the reverse side of front door parting seal front using a remover tool (A), and th ...
Charging System Preliminary Inspection
Inspection Procedure
CHECK 12V BATTERY TERMINALS CONNECTION
Check if 12V battery terminals are clean and tight.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair 12V battery terminals connection.
CHECK “B” TERMINAL CONNECTION
Check if “B” terminal (alternator ground h ...