NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Second Seat Belt Buckle

Nissan Armada 2025-2026 Service and Repair Manual / Restraints / Seat Belt / Second Seat Belt Buckle

Removal and Installation

REMOVAL

Captain Seat

Remove inside seat cushion finisher outer. Refer to Disassembly and Assembly.

Disconnect seat belt buckle harness connector and disengage harness clips.

Remove seat belt buckle mounting anchor bolt, and then remove seat belt buckle.

Bench Seat

Remove the following part.

  • Seat cushion trim and pad as a set (seat belt buckle LH): Refer to Disassembly and Assembly.

  • Inside seat cushion finisher outer (seat belt buckle RH): Refer to Disassembly and Assembly.

  • Inside seat cushion finisher outer (center seat belt buckle): Refer to Disassembly and Assembly.

Disconnect seat belt buckle harness connector and disengage harness clips.

Remove seat belt buckle mounting anchor bolt, and then remove seat belt buckle.

INSTALLATION

Install in the reverse order of removal.

Inspection

AFTER A COLLISION

WARNING:

To avoid the risk of death or severe injury:

  • Inspect all seat belt system components including the seat belt webbing, retractors, pretensioners, buckles, anchors, and attaching hardware after any collision.

  • Inspect all seat belt assemblies and components including webbing, retractors, buckles, anchors and attaching hardware not in use during a collision. Replace if either damage or improper operation is noted.

  • Failure to follow any of the above steps could result in serious personal injury in an accident.

Replace any seat belt assembly (including anchor bolts) if:

  • The seat belt is in use at the time of a collision (except for minor collisions and the belts, retractors and buckles show no damage and continue to operate properly).

  • The seat belt is damaged in an accident (i.e. torn webbing, bent retractor or guide, etc.).

  • The seat belt attaching point is damaged in an accident. Inspect the seat belt attaching area for damage or distortion and repair if necessary before installing a new seat belt assembly.

  • Anchor bolts are deformed or worn out.

  • The seat belt assembly must be replaced even if the seat belts were not in use during the collision in which the air bags were deployed.

PRELIMINARY CHECKS

Check the seat belt warning lamp for proper operation. Refer to Seat Belt Warning Lamp.

If the air bag warning lamp turns ON, perform self-diagnosis using CONSULT. Refer to CONSULT Function.

Check that the seat belt retractor, seat belt anchor and buckle bolts are tightened firmly.

Repeat steps above if necessary to check the other seat belts.

    Other materials

    Thigh Support
    Diagnosis Procedure CHECK THIGH SUPPORT MECHANISM Check for the following. Mechanism deformation or pinched foreign materials. Interference with other parts because of poor installation. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning par ...

    Additional Service When Replacing Bcm
    Description CAUTION: When replacing the BCM, always replace it with a new one. The functions controlled by the BCM does not operate properly in case of reuse of the BCM from another vehicle. When before pairing of BCM and Intelligent Key unit, always writing the BCM configuration. Or not doing s ...

    Additional Service When Replacing Audio Amp.
    Work Procedure CAUTION: When after replacing audio amp, Configuration must be performed. Or not doing so, audio amp. control function does not operate normally.REPLACE AUDIO AMP. Replace audio amp. Refer to Removal & Installation. >> GO TO 2. PERFORM AUDIO amp. CONFIGURATION Perform aud ...