Diagnosis Procedure
CHECK DTC OF AIR BAG DIAGNOSIS SENSOR UNIT
Check DTC in “Self Diagnosis Result” mode of “AIR BAG” using CONSULT.
Is DTC detected?
YES>>Perform trouble diagnosis related to the detected DTC. Refer to DTC Index.
NO>>GO TO 2.
CHECK DTC OF BCM
Check DTC in “Self Diagnosis Result” mode of “BCM” using CONSULT.
Is DTC detected?
YES>>Perform trouble diagnosis related to the detected DTC. Refer to DTC Index.
NO>>GO TO 3.
CHECK COMBINATION METER
Check combination meter. Refer to Work flow.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Repair or replace the malfunctioning parts.
CHECK HARNESS CONNECTOR
Check the harness connector for disconnection, looseness or damage.
Is the inspection result normal?
YES>>GO TO 5.
NO-1>>Damage: Replace malfunctioning harness and connector.
NO-2>>Disconnection or looseness: Securely lock the connector.
CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES>>GO TO 6.
NO>>Replace malfunctioning harness and connector.
CHECK SEAT BELT BUCKLE SWITCH (DRIVER SIDE)
Check seat belt buckle switch (driver side). Refer to Component Function Check.
Is the inspection result normal?
YES>>GO TO 7.
NO>>Repair or replace the malfunctioning parts.
CHECK SEAT BELT BUCKLE SWITCH (SECOND SEAT/THIRD SEAT)
Check seat belt buckle switch (second seat/third seat). Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 8.
NO>>Repair or replace the malfunctioning parts.
CHECK METER SPEAKER
Check meter speaker. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 9.
NO>>Repair or replace the malfunctioning parts.
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
Replace air bag diagnosis sensor unit. Refer to Removal & Installation.
Is the inspection result normal?
YES>>INSPECTION END
NO>>GO TO 10.
REPLACE BCM
Replace BCM. Refer to Removal and Installation.
Is the inspection result normal?
YES>>INSPECTION END
NO>>GO TO 11.
CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
>>
INSPECTION END
Other materials
Engine Lubrication System Tools and Preparation
Special Service Tools
The actual shapes of TechMate tools may differ from those of special service tools illustrated here.
Tool number
(TechMate No.)
Tool name Description
ST25051001
(NI-25695-1)
Oil pressure gauge
Measuring oil pressure
Maximum measuring range: 2,452 kPa (25 kg/cm2, 356 psi ...
Rear Propeller Shaft
Inspection
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
LOOSENESS OF CONNECT ...
Telematics Antenna
Removal & Installation
REMOVALRemove the instrument panel assembly. Refer to Removal and Installation.
Remove the screw and clips to remove the telematics antenna .
: Clips
INSTALLATIONInstall in the reverse order of removal.
Feeder Layout
Telematics antenna
TCU
: Crip
...