Inspection
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
LOOSENESS OF CONNECTED PART
Check each fixing bolt and nut for looseness using torque wrench. For each tightening torque, refer to Exploded View.
BACKLASH OF JOINT PART
Move the joint of propeller shaft up and down and from side to side (axial direction of shaft and right angle to shaft) to check that the joint has no backlash extremely. If the joint has a malfunction, remove propeller shaft and perform inspection.

APPEARANCE AND NOISE
Check propeller shaft tube surface for dents or cracks. If malfunction is detected, replace propeller shaft assembly.
VIBRATION
If vibration is present at high speed, adjust the propeller shaft phase first.
Check the propeller shaft for bend and damage. If damaged, replace propeller shaft assembly.
Perform a cruise test drive to check the propeller shaft for runout. If vibration occurs, separate propeller shaft at final drive companion flange; then change the phase between companion flange and propeller shaft by the one bolt hole at a time and install propeller shaft.
If vibration is still detected, measure propeller shaft runout after removing it. Refer to Inspection.
Other materials
Manual operation
Basic information
In the Nissan Armada, the electronic parking brake can also be controlled manually
using the dedicated switch, allowing precise control in various driving and parking
situations.
To apply: When the Nissan Armada is completely stopped and the
ignition switch is in the ON or ...
Front Door Outside Handle
Removal and Installation
REMOVALRemove front door finisher. Refer to Removal and Installation.
Remove front door module assembly. Refer to Removal and Installation.
Disconnect front door outside handle harness connector , and then disengage front door outside handle harness connector fixing clip (i ...
Tcu
Exploded View
Steering member
Bracket
TCU
: Pawl
Removal & Installation
REMOVALCAUTION:
Before replacing TCU, perform “ADDITIONAL SERVICE WHEN REPLACING TCU". For details, refer to Work Procedure.Remove the glove box assembly. Refer to Removal and I ...