Use recommended gear oil only. Refer to Fluids and Lubricants.
Clean and flush the parts sufficiently and blow-dry them.
Be careful not to damage sliding surfaces and mating surfaces.
Always use shop paper for cleaning the inside of components.
Never use cotton gloves or shop rags to prevent entering of lint.
Precaution for Electronic Air Suspension System
PreparationWork Procedure
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the display unit. For details the operation, refer to "CONSULT Operation Manual".
Work Procedure [Display Unit]
WRITING VEHICLE SPECIFICATION
With CONSULT
Perform writing vehicle specificat ...
Work Procedure
CHOOSE METHOD
There are two ways of initialization method.
Which method do you choose?
With CONSULT>>
GO TO 2.
Without CONSULT>>
GO TO 3.
WITH CONSULT
With CONSULT
Ignition switch ON.Perform "Third seat LH position initialization" in "Work support" mode of "THIRD SEAT RH" using CONSUL ...
NVH Troubleshooting Chart
Possible cause and SUSPECTED PARTS Symptom Reference DRIVE SHAFT FRONT AXLE Noise Shake Noise Shake Vibration Shimmy Judder Poor quality ride or handling Excessive joint angle × × — — — — — — Inspection Joint sliding resistance × — — — — — — ...