Removal and Installation
Exploded ViewRemoval & Installation
REMOVAL
Remove the headlining assembly. Refer to Removal and Installation.
Remove the roof antenna harness connector.
Remove roof antenna mounting nut , and then remove roof antenna.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Be careful about tightening torque. If the tightenin ...
Inspection
MAGNETIC SWITCH
Remove starter motor from vehicle. Refer to Removal and Installation.
Connect 12V battery to starter motor as shown in the figure. Check that pinion gear is driven out by magnetic switch.
Replace starter motor if pinion gear is not driven out.
Disconnect “M” terminal as show ...
Exploded View
Sub harness Knock sensor Cylinder block Oil gallery cover Gasket Plug O-ring Rear oil seal Oil jet Main bearing (upper) Crankshaft Thrust bearing Main bearing (lower) Plug Gasket Lower cylinder block Baffle plate Top ring Second ring Oil ring Piston Piston pin Snap ring Conn ...