WARNING:
Perform self-diagnosis using CONSULT before the symptom diagnosis. Perform trouble diagnosis if any DTC is detected. Refer to DTC Index.
| Symptom | Possible cause | How to solve |
|---|---|---|
| Vehicle height is not risen/fallen | Engine is stopped | Start the engine. |
| Each switch is OFF | Check the staus of the switch. | |
| Electric Air Suspension system is OFF |
| |
| Door is opening | Close the door. | |
| Food is opening | Close the food. | |
| The compressor is overheated due to repeated intentional raising and lowering | Wait a few minutes until the compressor cools down. | |
| The vehicle is overloaded | Reduce the number of loads on the vehicle. | |
| Does not perform appropriate work after replacing parts of air suspension | Perform the work after replacing parts. Refer to Work Procedure. | |
| A foreign object is trapped inside Wheel house | Remove the foreign object. | |
| Air leaks slowly (Air slowly escapes through a small hole) | Perform diagnosis procedure of DTC:C1C60-64 (Identification of air leak location) Refer to Diagnosis Procedure. | |
| 12 V battery is low | Charge or inspect 12 V battery. | |
| The vehicle and obstacle is in contact | Remove obstacles. | |
| The vehicle is leaning | Height sensor bracket is winding | Replace to height sensor. Refer to Removal and Installation. (front height sensor) or Removal and Installation (rear height sensor). |
| A foreign object is trapped inside wheel house | Remove the foreign object. | |
| Engine is stopped while vehicle height is transitioning | Restart the engine and operate.
| |
| Air Tube is installed by mistake (Air Tube for right side is installed left side etc.) | Install air tube correctly. | |
| Adjustment speed of vehicle height is low | Tire movement during vehicle height change is obstructed by wheel chocks and so on | Remove obstacles like wheel chocks from tires.
Check if the safety is ensured before remove wheel chocks. |
| Vehicle height change is obstructed because friction occurs between suspension parts. | Drive the vehicle lightly. | |
| Operation sound occurs | Operation sound occurs while vehicle height is transitioning | It is normal operating condition.
Operation sound occurs from compressor while vehicle height is transitioning. |
Removal and Installation
CAUTION:
REMOVAL
Remove driver knee air bag module mounting bolts, and then move driver knee air bag module to secure workspace. Refer to Removal and Installation.
Disconnect harness connector.
Remove fixing clip , and then remove front foot lamp bracket (LH).
Disengage front foot lamp (LH) fixing ...
Exploded View
Rear final drive assembly Side oil seal : Vehicle front : Always replace after every disassembly. ...
Explanation of scheduled maintenance items
Basic information
The following section provides a detailed overview to help you better understand
the scheduled maintenance requirements for your Nissan Armada. These descriptions
explain why each service item is important and how it contributes to the long-term
reliability, safety, and perf ...