| Symptoms | Inspection item/Reference page | |
|---|---|---|
| Operation | System setting cannot be turned ON/OFF | Refer to Diagnosis Procedure |
| System cannot be set (ProPILOT Assist switch turns ON/OFF) | Refer to Diagnosis Procedure | |
| CANCEL switch does not function | ECM Refer to DTC Index | |
| Resume does not function | ||
| Set speed does not increase | ||
| Set distance to a vehicle ahead cannot be changed | ||
| System does not cancel when shift position sets ON "N" | ECM Refer to DTC Index | |
| Chime | Chime does not sound | Combination meter Refer to DTC Index |
| Control | Driving force is hunting | Refer to Diagnosis Procedure |
| Function to detect a vehicle ahead | System frequently cannot detect a vehicle ahead | Refer to Diagnosis Procedure |
| Distance to detect a vehicle ahead is short | ||
| System misidentifies a vehicle even though there is no vehicle ahead |
| |
| System misidentifies a vehicle in the next lane | ||
| The system does not detect the vehicle ahead at all | Refer to Diagnosis Procedure | |
| Operation | Turn signal operates even using turn signal | Refer to Diagnosis Procedure |
Removal and Installation
CAUTION:
REMOVAL
Fully open back door.
Apply protective tape (A) on the part to protect it from damage.
Disengage rear combination lamp cover fixing pawls using a remover tool (A), and then remove rear combination lamp cover.
: Pawl
Remove rear combination lamp mounting bolts .
Apply protec ...
Rear Disc Brake
Unit: mm (in)
Item Limit Brake pad Wear thickness 1.5 (0.059) Disc rotor Wear thickness 18.5 (0.728) Thickness variation (measured at 8 positions)* 0.009 (0.0004) Runout (with it attached to the vehicle) 0.07 (0.0028)
*To check if rotor imbalance, rotor runout or rotor deformation is oc ...
Inspection
WARNING:
OIL LEAKAGE
Make sure that oil is not leaking from final drive assembly or around it.
OIL LEVEL
CAUTION:
The ignition switch OFF while checking oil level.
Oil level should be level with bottom of filler plug hole. Add gear oil if necessary. Refer to Refilling.
Set a gasket on filler plug ...