Removal & Installation
REMOVAL
Remove the map lamp assembly. Refer to Removal and Installation.
Remove the microphone harness connector 
.
Use a suitable tool to release pawl and remove the switch finisher 
.
 |
: Pawls |
CAUTION:
Do not damage pawl.
Use a suitable tool to release pawls and remove the moonroof switch assembly (telematics switch) .
|
: Pawls |
CAUTION:
Do not damage pawl.
INSTALLATION
Installation is the reverse order of removal.
NOTE:
Check the telematics switch for looseness after the installation.
Other materials
Rear Wheel House Protector
Exploded View
Rear wheel house protector
Grommet
U nut
Removal and Installation
WARNING:
REMOVALRemove rear wheel house protector mounting bolts, nuts, and fixing clips, and then remove rear wheel house protector.
Remove U nut from rear wheel house protector.INSTALLATIONInstall in ...
Combination Switch
Removal and Installation
REMOVALCAUTION:
Never reuse combination switch. Always replace it with a new one when it is removed.Remove spiral cable. Refer to Removal & Installation.
Disconnect harness connector from combination switch.
Remove the combination switch mounting screw .
Pull out the ...
Propilot Assist 2.1
Propilot Assist 2.1 System Symptoms
Symptom Table
Check whether symptom is due to normal operation before performing diagnosis. Refer to Precautions for ProPILOT Assist 2.1. Symptoms Reference page
ProPILOT Assist 2.1 cannot be turned ON
Diagnosis Procedure
vehicle speed/vehicle-to-vehicle ...