Diagnosis Procedure
Diagnosis ProcedureRemoval and Installation
REMOVAL
Remove front evaporator. Refer to Removal and Installation.
Disconnect sub harness connector from intake sensor harness connector.
Remove intake sensor harness connector from front case upper.
Remove intake sensor from front evaporator.
CAUTION:
Mark the mounting position of intake se ...
Removal and Installation
WARNING:
REMOVAL
CAUTION:
Wipe off immediately when attaching brake fluid with disc rotor and caliper assembly.
Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.
Drain brake fluid. Refer to Draining.
Loosen the flare nut with a flare nut wrench (A) and separate the brake tube f ...
Inspection
MAGNETIC SWITCH
Remove starter motor from vehicle. Refer to Removal and Installation.
Connect 12V battery to starter motor as shown in the figure. Check that pinion gear is driven out by magnetic switch.
Replace starter motor if pinion gear is not driven out.
Disconnect “M” terminal as show ...