| Dimension between end of converter housing and torque converter | 21.2 mm (0.831 in) |
Vehicle Speed at Which Lock-up Occurs/ReleasesRemoval and Installation
REMOVAL
Remove cowl top side seal between cowl top cover and fender drip cover. Refer to Removal and Installation.
Disengage fixing clips, and then remove front fender drip cover.
: Clip
Disengage fixing clips, and then remove hood side seal.
INSTALLATION
Install in the reverse order of removal ...
Removal and Installation
REMOVAL
Fully close rear door glass.
Remove rear door woofer. Refer to Removal & Installation.
Remove rear door check link mounting bolt of vehicle body side.
Remove rear door check link mounting bolts of rear door panel, and then take rear door check link out from the hole of rear door panel.
I ...
Inspection
INSPECTION AFTER REMOVAL
Move joint up/down, left/right, and in the axial directions. Check for motion that is not smooth and for significant looseness.
Check boot for cracks, damage, and leakage of grease.
Disassemble drive shaft and exchange malfunctioning part if there is a non-standard conditio ...