Exploded View
 |
Transfer control unit | ||||
 |
: N·m (kg-m, in-lb) |
Removal and Installation
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVAL
The ignition switch OFF.
CAUTION:
Wait for 60 seconds after the ignition switch OFF.
Disconnect negative battery terminal. Refer to Removal and Installation.
Remove glove box cover. Refer to Removal and Installation.
Disconnect transfer control unit harness connector.
Remove transfer control unit bracket mounting nuts (
) and remove transfer control unit with bracket.
INSTALLATION
Note the following, and install in the reverse order of removal.
-
When replacing transfer control unit, performe writing unit parameter and intial calibration. Refer to Description.
Other materials
Intelligent Key Unit
Removal and Installation
REMOVALCAUTION:
When replacing the Intelligent Key unit, always replace it with a new one. The functions controlled by the Intelligent Key unit does not operate properly in case of reuse of the Intelligent Key unit from another vehicle.Remove luggage side lower finisher LH. ...
Power Outlet. Power Socket
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front ...
Lan System. Can Gateway
Additional Service When Replacing 8ch Can Gateway
Description
When replacing the 8CH gateway, perform "Procedure before replacing" and "Procedure after replacing". Refer to Work Procedure.CAUTION:
Never reuse the parts which has been dropped
Dispose 8CH CAN gateway which is paired with Intelli ...