Inspection
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
FLUID LEAKAGE
Check transfer surrounding area (oil seal, drain plug, and filler plug etc.) for fluid leakage.
FLUID LEVEL
Remove filler plug 
. Then check that fluid is filled up from mounting hole for the filler plug.
CAUTION:
Never start engine while checking fluid level.
Install filler plug on transfer and then tighten to the specified torque.
CAUTION:
Never reuse filler plug.
| Specified torque | : 37.5 N·m (3.8 kg-m, 28 ft-lb) |
Draining
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
The ignition switch OFF.
Remove the drain plug .
Drain transfer fluid.
Install drain plug to transfer and tighten to the specified torque.
CAUTION:
Never reuse drain plug.
| Specified torque | : 37.5 N·m (3.8 kg-m, 28 ft-lb) |
Refilling
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
The ignition switch OFF.
Remove filler plug . Fill up with new transfer fluid up to mounting hole for the filler plug.
| Recommended fluid and capacity: | Refer to Fluids and Lubricants. |
CAUTION:
Carefully fill the fluid. (Fill up for approximately 3 minutes.)
Leave the vehicle for 3 minutes, and check the fluid level again.
Install filler plug on transfer and tighten to the specified torque.
CAUTION:
Never reuse filler plug.
| Specified torque | : 37.5 N·m (3.8 kg-m, 28 ft-lb) |
Other materials
System maintenance
Example
Basic information
The two radar sensors A for the I-BSI system are located near the rear bumper.
Always keep the area near the radar sensors clean.
The radar sensors may be blocked by temporary ambient conditions such as snow,
splashing water, mist or fog.
The blocked condition ma ...
Noise, Vibration and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and suspected parts SYMPTOM Reference
Noise Shake Vibration Shimmy Judder Poor quality ride or handling
Improper installation, looseness
×
×
×
...
Brake Pad
Exploded View
Cylinder body
Inner shim cover
Inner shim
Inner pad (with pad wear sensor)
Return spring
Pad retainer
Torque member
Outer pad
Outer shim
Outer shim cover
: vehicle front
1: Apply MOLYKOTE® AS880N or siliconebased grease. ...