Nissan Armada 2025-2026 Service and Repair Manual: Unit Parameter Writing
After working the following, transfer unit parameter must be written to transfer control unit.
Transfer control unit replacing
Transfer assembly replacing
Transfer control actuator replacing
Transfer range position sensor replacing
Transfer case component parts disassembling
NOTE:
Write charactereistic value in transfre control unit, if the above each parts is replaced.
For the work procedure, refer to Work Procedure.
Work Procedure
WRITING THE REQUIRED INFORMATION FOR CONTROL UNIT REPLACEMENT
With CONSULT
Ignition switch ON.
Select "AWD/4WD".
Select "Replace ECU".
Perform the work according to the procedure displayed in CONSULT. ...
Work Procedure
WARNING:
UNIT CHARACTERISTIC VALUE CONFIRMATION
Confirm the 5-digit alphanumeric unit characteristic value written in the QR code pasted on the side or top of the transfer assembly.
: Side surface ...
Other materials:
Diagnosis Procedure
COMBINATION SWITCH INSPECTION
Check combination switch. Refer to Symptom Table.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning part.
CHECK LOW BEAM REQUEST SIGNAL
With CONSULT
Select “Low beam request” in “Data Monitor” mode of “ ...
Removal and Installation
WARNING:
REMOVAL
Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.
Remove brake hose bracket. Refer to Removal and Installation.
CAUTION:
Never depress brake pedal while brake caliper is removed.
Remove disc rotor.
CAUTION:
Never drop disc rotor.
Remove wheel sensor harness. Re ...
Basic information
WARNING
Never attempt to lift two wheels of the Nissan Armada off the ground
while the engine is running and shift the transmission into any drive or reverse
position. This improper procedure may cause severe drivetrain damage or unexpected
vehicle movement, potentially leading to serio ...
0.006