Work Procedure
Work ProcedureAdditional Service When Replacing Sonar Control Unit
CAUTION:
When replacing the sonar control unit, always replace it with a new one. Sonar system does not operate properly in case of reuse of the sonar control unit from another vehicle.
When before writing the sonar control unit configuration, always writing the MAC key.
Perform the following opera ...
Removal and Installation
REMOVAL
Remove rear door finisher. Refer to Removal and Installation.
Remove rear door inner frame. Refer to Removal and Installation.
Disconnect rear door outside handle harness connector , and then disengage rear door outside handle harness connector fixing clip (if equipped).
: Vehicle front ...
Adjustment
TOTAL PRELOAD TORQUE
Remove side shaft. Refer to Disassembly and Assembly.
Rotate drive pinion back and forth 2 to 3 times to check for unusual noise and rotation malfunction.
Rotate drive pinion at least 20 times to check for smooth operation of the bearing.
Measure total preload with the preload g ...