Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure
WARNING:
REPLACE CONTROL VALVE & TCM
Replace control valve & TCM. Refer to Removal and Installation.
>>GO TO 2.
REFILL A/T FLUID
Refill A/T fluid. Refer to Changing.
NOTE:
Just fill A/T fluid in this step, A/T fluid level is adjusted in the step 4.
>>GO TO 3.
CALIBRATE PARK POSITION SENSOR AND WRITING Vehicle SPECIFICATIONS
With CONSULT
Ignition switch ON.
Select "TRANSMISSION".
Select "Replace ECU".
Perform the work according to the procedure displayed in CONSULT.
CAUTION:
If the shift position is not displayed on the combination meter after writing the vehicle specifications, confirm that the shift position is displayed on the combination meter after performing one of the following actions.
Turn the ignition switch OFF and wait until the combination meter turns off. Then turn the ignition switch ON.
Disconnect the 12V battery terminal and reconnect it. Then turn the ignition switch ON. Refer to Precautions for Removing Battery Terminal.
GO TO 4.
ADJUST A/T FLUID LEVEL
Adjust A/T fluid level. Refer to Adjustment.
>>GO TO 5.
PERFORM TORQUE CONVERTER CLUTCH POINT LEARNING
Perform torque converter clutch point learning. Refer to Descripton.
>>GO TO 6.
CALIBRATE DECEL G SENSOR
Perform decel G sensor calibration. Refer to Description.
Clear any DTCs that may have set and then test drive the vehicle.
WORK END
Additional Service When Replacing Control Valve & Tcm
WARNING:
When replacing the control valve & TCM, perform the following work. For work procedure, refer to Work Procedure.
A/T fluid filling
Calibration of park position sensor
Vehicle specificatio ...
Additional Service When Replacing Electric Shift Selector
When electric shift selector is replaced, always perform "Replace ECU" of CONSULT function to write vehicle specifications. For work procedure, refer to Work Procedure. ...
Other materials:
Inspection Procedure
INSTRUMENT PANEL
Most incidents are caused by contact and movement between:
Cluster lid A and instrument panel
Acrylic lens and combination meter housing
Instrument panel to front pillar garnish
Instrument panel to windshield
Instrument panel mounting pins
Wiring harnesses behind the combination met ...
Diagnosis Procedure
CHECK DTC OF AIR BAG DIAGNOSIS SENSOR UNIT
Check DTC in “Self Diagnosis Result” mode of “AIR BAG” using CONSULT.
Is DTC detected?
YES>>
Perform trouble diagnosis related to the detected DTC. Refer to DTC Index.
NO>>
GO TO 2.
CHECK COMBINATION METER
Check combination meter. Refe ...
SERVICE NOTICE AND PRECAUTIONS FOR ROAD WHEEL : Precautions
Genuine NISSAN aluminum wheel is designed for each type of vehicle. Use it on the specified vehicle only.
Use Genuine NISSAN parts for the wheel nuts.
Always use them after adjusting the wheel balance. For the balance weights, use Genuine NISSAN aluminum wheel weights.
Use caution when handling the ...
0.0053