Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure
CHOOSE METHOD
There are two ways of learning method.
Which method do you choose?
With CONSULT>>GO TO 2.
Without CONSULT>>GO TO 3.
WITH CONSULT
With CONSULT
Ignition switch ON.
Perform "Steering column position learning” in "Work support" mode of "STEERING COLUMN” using CONSULT.
WORK END
WITHOUT CONSULT
Without CONSULT
Disconnect battery terminal.
Connect battery terminal.
Activate exit assist function. Refer to exit assist function system.
WORK END
Perform the Steering Column Position Learning
Perform the steering column position learning when the following conditions are performed. For details, refer to Work Procedure.
Replacing steering column control module.Steering column does not opera ...
Memory Storing
Always perform the memory storage when the driver seat control unit or steering column control module is replaced. The memory function will not operate normally if no memory storage is performed. For ...
Other materials:
Use of Body Filler (putty) and Grinding
Panel irregularities may be corrected with a hammer and dolly. However, exact restoration of the original shape with these tools takes a long time. Body filler may be used to restore the original panel profile. For this purpose, the panel surface is finished slightly lower than the original surface. ...
When SRS is not activated in a collision
CAUTION:
WORK PROCEDURE
Check the SRS components and the related parts using the following table.
If the front seatback assembly is damaged, the front seatback assembly must be replaced.
If the rear seatback assembly is damaged, the rear seatback assembly must be replaced.
If the door finisher assem ...
Inspection
WARNING:
OIL LEAKAGE
Make sure that oil is not leaking from final drive assembly or around it.
OIL LEVEL
CAUTION:
The ignition switch OFF while checking oil level.
Set a gasket on filler plug and install it on final drive assembly.
CAUTION:
Never reuse gasket.
Tighten filler plug to the specified ...
0.0053